ClipMate Support Forum

Hi all (and Chris),

It's been so long since I've had any problems that the last time I needed support this board didn't exist or at least I didn't know about it.
Well, as stated in the subject, I woke up my comp this morning to a message from CM saying there was an error. The message said it would be safe to continue running it (yes or no box) and I tried to continue. Moments later the message returned, etc. etc. I then shut it down (CM) and tried to reboot it and got "the" microsoft msg.

Name: clipmt53.exe AppVer: 5.3.9.289 ModName: kernel32.dll
ModVer: 5.1.2600.5781 Offset: 00012afb

and here's the error msg:

v5.3.09 @8/8/2009 1:41:47 PM err:Access violation at address 00449009 in module 'ClipMt53.exe'. Read of address FFFFFFFF In:TfrmCM.UpdateMagView - After all tabs are done showing( 0)
v5.3.09 @8/8/2009 1:41:49 PM err:Access violation at address 00449009 in module 'ClipMt53.exe'. Read of address FFFFFFFF In:TfrmCM.UpdateMagView - After all tabs are done showing( 0)
v5.3.09 @8/8/2009 1:41:49 PM err:Access violation at address 00449009 in module 'ClipMt53.exe'. Read of address FFFFFFFF In:TfrmCM.UpdateMagView - After all tabs are done showing( 0)
v5.3.09 @8/8/2009 1:41:49 PM err:Access violation at address 00449009 in module 'ClipMt53.exe'. Read of address FFFFFFFF In:TfrmCM.UpdateMagView - After all tabs are done showing( 0)
v5.3.09 @8/8/2009 1:41:49 PM err:Access violation at address 00449009 in module 'ClipMt53.exe'. Read of address FFFFFFFF In:TfrmCM.UpdateMagView - After all tabs are done showing( 0)
v5.3.09 @8/8/2009 1:44:46 PM err:Access violation at address 00449009 in module 'ClipMt53.exe'. Read of address FFFFFFFF In:TfrmCM.UpdateMagView - After all tabs are done showing( 0)

Hope this is enough info because I have no idea of what it means but I'm lost without my clipmate!!!

Art

Unisntall/Re-install.
If that doesn't help, delete or rename the database directory and restore from backup. ClipMate 5 doesn't have its own backup, so you'll have to resort to whatever backup method you use for backing up your own data.

_________________
I'm the ClipMate Guy!